User Tools

Site Tools


roland_dj-505

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
roland_dj-505 [2019/11/27 07:22]
hlzhs [Audio Setup]
roland_dj-505 [2020/03/03 04:18] (current)
hlzhs
Line 145: Line 145:
 Most pad modes are similar to those found when used with Serato. A notable exception is the Loop Mode, which replaces the Serato'​s Saved Loop Mode. In this mapping, the Loop Mode is similar to the Roll mode, but sets a non-rolling beatloop instead. Most pad modes are similar to those found when used with Serato. A notable exception is the Loop Mode, which replaces the Serato'​s Saved Loop Mode. In this mapping, the Loop Mode is similar to the Roll mode, but sets a non-rolling beatloop instead.
  
-  * **Hot Cue Mode:** Press a pad that is unlit to assign a hot cue point to it. If a pad is lit, press it to start playback from the hot cue location. Hold [SHIFT] and a pad to clear the hot cue. Use the PARAMETER BUTTONS for moving the beatgrid left/right.+  * **Hot Cue Mode:** Press a pad that is unlit to assign a hot cue point to it. If a pad is lit, press it to start playback from the hot cue location. Hold [SHIFT] and press a pad to clear the hot cue. After setting or using a hot cue, use the PARAMETER BUTTONS to change its color. Use the PARAMETER BUTTONS ​while holding [SHIFT] ​for moving the beatgrid left/right.
   * **Cue Loop Mode:** When the deck is playing and a pad that is lit is pressed, auto loop will start from the location of the hot cue point that is assigned to the pad. If the pad is not lit, a hot cue is specified at the current location and auto loop starts immediately.   * **Cue Loop Mode:** When the deck is playing and a pad that is lit is pressed, auto loop will start from the location of the hot cue point that is assigned to the pad. If the pad is not lit, a hot cue is specified at the current location and auto loop starts immediately.
   * **Roll Mode:** While holding down a performane pad, a rolling loop plays with the beatlength that is assigned to the pad. The pad that creates a roll of 4 beats length is illuminated. Each pad to the right doubles the length, left halves it. You can use the PARAMETER buttons to cycle through four sets, as described in the Owner'​s Manual.   * **Roll Mode:** While holding down a performane pad, a rolling loop plays with the beatlength that is assigned to the pad. The pad that creates a roll of 4 beats length is illuminated. Each pad to the right doubles the length, left halves it. You can use the PARAMETER buttons to cycle through four sets, as described in the Owner'​s Manual.
roland_dj-505.txt ยท Last modified: 2020/03/03 04:18 by hlzhs