User Tools

Site Tools


behringer_cmd_mm-1_advanced_mapping

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
behringer_cmd_mm-1_advanced_mapping [2018/04/01 09:10]
swiftb0y Added note to point out the changed functionality of the out-knobs
behringer_cmd_mm-1_advanced_mapping [2018/04/01 09:51] (current)
be.ing
Line 54: Line 54:
 {{:​hardware:​behringer:​behringercmdmm1-toprowlabeled.png?​800|}} {{:​hardware:​behringer:​behringercmdmm1-toprowlabeled.png?​800|}}
  
-**NOTE:** +The Out 1 knob controls ​the Master balance ​and the Out 2 knob controls the Master ​gain.
-The Out-Knobs now affect ​the Master balance/gain.  +
  
-<​del>​The Out1 and Out2 buttons didn't have any obvious functionality so they control the knobs of the EffectUnits. +You can see the L/R buttons besides ​the encoder as Shift and Ctrl buttons.
-You can see that they control ​the super-knobs of FxUnit1 & FxUnit2 in normal mode (no formating),​ +
-The mix-knobs of FxUnit1 & FxUnit2 in shift mode (//​italic//​),​ +
-the super-knobs of FxUnit3 & FxUnit4 in ctrl mode (**bold**) +
-and the mix-knobs of FxUnit3 & FxUnit4 in thirdMode (**//​bold&​italic//​**).</​del>​+
  
-You can see the L/R buttons besides the encoder ​as shift- and ctrlbuttons. +The encoder in the middle is able to browse the library and jump on the preview deck (16 steps) while holding shift. 
- +When pressing the encoder, the selected/​highlighted track in the library gets loaded into the preview deck
-The Encoder ​in the middle is able to browse the library and jump on the previewdeck ​(16 steps) while holding shift. +The preview deck can be played/​paused when holding shift while pressing the encoder down.
-When pressing the encoder, the selected/​highlighted track in the library gets loaded into the previewdeck+
-The Previewdeck ​can be played/​paused when holding shift while pressing the encoder down.+
  
 The Cue Vol/Mix knobs have no alternative functionality. The Cue Vol/Mix knobs have no alternative functionality.
Line 147: Line 140:
 ==== Troubleshooting ==== ==== Troubleshooting ====
  
-MY CONTROLLER DOESNT LIGHT UP, HELP!!!11+=== Controller does not light up ===
  
 The issue is probably the Midi-Channel of your MM-1. The issue is probably the Midi-Channel of your MM-1.
behringer_cmd_mm-1_advanced_mapping.txt · Last modified: 2018/04/01 09:51 by be.ing