DIY 3D print controler

General Mixxx discussion.... discuss

Moderator: garth

DIY 3D print controler

Postby tekman » Sun May 10, 2020 8:47 am

Hello,

Nice to meet you, I would like to thank you for this very good software.
I would know, sorry if it's been already asked, if a 3D printed controller with a rotating central wheel on bearing and sensor as any other band controller could be done.
The software run on Raspberry pi flawlessly so it could be integrated inside with a LCD display.

I build a Linux laser show projector so the controller could also control lasers.
Regards
Seb
tekman
 
Posts: 2
Joined: Sun May 10, 2020 8:38 am

Re: DIY 3D print controler

Postby dj_estrela » Mon May 18, 2020 8:36 pm

have no knowledge of 3D print, but something somewhat close is this Arduino-based controller
which is very similar to the Akai AMX controller

https://www.musiconerd.com/traktorino
Dell XPS 15 model 9560 + Windows 10 (1809)
Pioneer DDJ-1000 + DDJ-SZ + AKAI AMX
dj_estrela
 
Posts: 22
Joined: Tue Apr 21, 2020 10:57 am

Re: DIY 3D print controler

Postby manas01 » Thu Jun 04, 2020 10:21 am

hello everyone,
I'm currently designing my own 3D printer and I was wondering if an Arduino with a servo shield and a raspberry pi would work for controlling the printer?
cartoonhd shareit
thanks in advanced
manas01
 
Posts: 1
Joined: Thu Jun 04, 2020 8:38 am

Re: DIY 3D print controler

Postby tekman » Wed Jun 10, 2020 3:37 pm

dj_estrela wrote:have no knowledge of 3D print, but something somewhat close is this Arduino-based controller
which is very similar to the Akai AMX controller

https://www.musiconerd.com/traktorino


Allright, thank you for the informations i will look this DIY project more in details asap.
I think the controller could look like a commercial version when printed in 3D, but that represents a lot of design
tekman
 
Posts: 2
Joined: Sun May 10, 2020 8:38 am


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 8 guests